Night Light Human Body

human body sensor light

One:introduction

        1.The light will be lighting in the dark condition when people come into the range around 3-6 meter near the light
and the light will off when people leaving after 20 second.

        2.In order to avoid the uncomfortable caused by light,the light is with the function of Gradient lights and lights
off.

        3.Constant current power supply,above 90% effectiveness.The light won't be darken within the range of
effectiveness of battery even the battery power be lowed.

        4.To meet the need of all different conditionl,the light can change the brightness after you press the button for
more than 2 seconds under the sensor mode and                 continuous mode.

        5.It can set up mode such as work mode，sensor mode，continuou light mode,Flash mode(Frequency 1Hz) to meen
different customer's need.

        6.If you inconvenient to charge or require long hours of workcan,you can use one 14500 lithium battery or three
AAA batteries,It's decided by you.

        7.Please charge the light in time or prepare three piece of AAA battery when the light became darken and Indicator
light flashed.
    


Two:Instructions for use


        1.Distance of sensor:3-6 meter,angle of sensor bigger then 120°,when people leaving this range,the light will off
after 20 second.

        2.Short button:Cut off--Automatic mode--continuou light mode--flash mode--cut off

        3.Long Button(under automatic mode or continuou light mode,press more then 2 second):current brightness--
Max.brightness--Mix.Brightness--Max.brightness--Mix.Brightness

        Remark:The adjust brightness can be different under automatic mode and continuou light mode.

        4.Indicator light introduction:Under Automatic mode,the light flash 5 second. 
                                       Under continuou light mode,the light flash 5 second.
         when finish charge,the indicator will be light.


Three:Specifiction

        Material of products:ABS+PC  light source: LED

        Charging voltage:DC5V   Power:0.2W--1.4W,Default  power is 0.5W.

        Battery:Three piece of AAA battery or 3.7V 14500 lithium battery.


Four:Installation Notes

        1.Paste the round iron in the place where need to illumination,draw the light on the iron

        2.It can Hanging the light on the Nails if there is no space can paste the round iron.

        3.Or you can put the light in the table or flat place directly.It's all decided by you:)